CAN module
The module allows you to read logistics information from CAN bus in the vehicle
Module read the data from the CAN bus (J1939/J1708/J1578/FMS/ OBDII) – over 900 vehicles and machines supported
Possibility to read the status of the tachograph and drivers card numbers (on the off ignition as well!)
Advanced ECODRIVING with the possibility of a dedicated configuration for selected vehicles
PLUG&PLAY - module includes a special algorithms that ensures the correctness of available parameters: the device is ready to work right after installing!
AUTOSYNC - automatic synchronization - after installing, the device automatically finds the model of the vehicle to which it is connected (100% efficiency); The module does not require any configuration after the installation
The guarantee of reading available parameters described in the list of supported vehicles
Precise information about the available parameters and a dedicated wiring diagram for the particular model of vehicle
CAN UNIFICATION - It means that all data is sent in the same units
Remote update and full configuration (via Terminal)
The CAN module is integrated in the terminal
Reading data from Renault and Volvo using the integrated internally J1708 bus (does not require connecting to any additional accessories)
Pulse - calibrated reading distance and fuel consumption right where total value is unavailable
The module remembers and provides a summed value (the course of the clocks; fuel consumption; acceleration; deceleration; engine running time and others...) It revolutionizes the time required to generate reports in the client application
Remote diagnostics of reading data problems from the CAN; the ability to add unsupported parameters using the diagnostic server
Ability to read DTC codes (Diagnostic Trouble Codes)
Ignition signal, engine conditions
Total vehicle mileage read from clocks
Engine rpm, vehicle speed
Fuel level
Total fuel consumption, Total fuel consumption at a standstill
The pressure on the gas pedal
Total drive time, total standstill time on running engine
Total running time of the engine (motohours)
Engine, oil and coolant temperature
Vehicle range (number of km to ride on the remaining fuel)
Instantaneous fuel consumption
Data from tachograph (connection by CAN): work mode of two drivers, card numbers of two drivers, drivers work time limit
Information about exceeded limits
Pressure on the axles (4 axles) and total vehicle weight
The use of engine torque, engine speed
The module counts rapid accelerations and brakings using advanced algorithms (the user can configurate parameters adjusting event to a vehicle model)
Exceeding the engine rpm speed (event)
The driving time on the exceeded speed (time)
The driving time on the exceeded rpm speed (time)
The driving time on exceeding the pressure on the gas pedal (time)
AdBlue level
VIN number of the vehicle
Vehicle registration number
Reading of additional information for electric vehicles (battery level, charging the vehicle)
Over 30 indicators and over 60 logistic information read from the CAN bus
New parameters available in the S10 series terminals:
- Ambient temperature
- Pressure on the brake pedal
- Driving times from the tachograph (which are currently only supported by TMR) (Coming soon)
- Steering wheel angle value (Coming soon)
- Turn Signal Lamps (Coming soon)
- Charging current (electric cars)
- Starting the engine
- Total driving time with the cold engine
- VIN - in most vehicles
- Parameters specific to heavy vehicles
- Check engine light - on most passenger vehicles
- Hazard lights - most passenger cars (Coming soon)
- Fuel level in % - now available on all vehicles (applies to vehicles with a reading of the parameter “fuel level”)
And much more
